How To Verify Valvetrain Geometry

The following is a method of verifying proper valve train geometry. After you have estimated the required pushrod length using a Lunati Pushrod Length Checker, use this method to verify that the valve train geometry is correct (using the rockers you are using in your engine.) Step 1 1The first step is to install a solid lifter and an adjustable pushrod. Mark the tip of the valve with a marker. Step 2 2Install your rocker arm and set it up with zero lash. Rotate the crankshaft clockwise several times. Remove the rocker arm. The contact pattern of the rocker tip will be where the marker has been wiped away from the valve tip. The pattern should be centered on the valve tip, and as narrow as possible. If it is not, experiment with varying the pushrod length to yield the best pattern. Step 3 3Rotate the crankshaft clockwise several times. Remove the rocker arm. The contact pattern of the rocker tip will be where the marker has been wiped away from the valve tip. The pattern should be centered on the valve tip, and as narrow as possible. If it is not, experiment with varying the pushrod length to yield the best pattern. Step 4a 4aPushrod Too Long: Notice how the pattern is wide, and shifted to the exhaust side of the valve tip Step 4b 4bPushrod Too Short: Notice how the pattern is wide, and shifted to the intake side of the valve tip. Step 4c 4cPushrod Length Correct: Notice how the pattern is narrow and is centered on the Source: http://www.lunatipower.com/Tech/Valvetrain/HowToVerifyValvetrainGeometry.aspx
It's only fair to share...Share on Facebook0Share on Google+0Tweet about this on TwitterShare on LinkedIn0